To the top of the document
Spark
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Automatic A/C Engine Coolant Temperature Sensor Replacement -- Left Hand Drive

Removal Procedure

  1. Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Remove the instrument panel (I/P) compartment. Refer to Instrument Panel Compartment Replacement .

  3. 2327760
  4. Remove the heater core pipe side cover screws (1).
  5. Remove the heater core pipe side cover (2).

  6. 2309309
  7. Disconnect the coolant temperature sensor electrical connector.
  8. Remove the coolant temperature sensor (1).

Installation Procedure


    2309309
  1. Install the coolant temperature sensor (1).
  2. Connect the coolant temperature sensor electrical connector.

  3. 2327760
  4. Install the heater core pipe side cover (2).
  5. Caution: Refer to Fastener Caution in the Preface section.

  6. Install the heater core pipe side cover screws (1) and tighten to 1.2 N·m (11 lb in).
  7. Install the I/P compartment. Refer to Instrument Panel Compartment Replacement .
  8. Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
   


© Copyright Chevrolet. All rights reserved