To the top of the document
Spark
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Heater and Air Conditioning Control Replacement -- Left-Hand Drive

Removal Procedure

    Warning: Refer to Battery Disconnect Warning in the Preface section.

  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Remove the instrument panel (I/P) compartment. Refer to Instrument Panel Compartment Replacement .
  3. Remove the radio. Radio Replacement .

  4. 2309274
  5. Remove the heater and air conditioning (A/C) control screws (1).

  6. 2309282
  7. Remove the heater and A/C control (4) by pulling it out to provide clearance for the removal of the cables.
  8. Note: Note the location of the cables to facilitate their re-installation.

  9. Disconnect the temperature control cable (1), mode control cable (2) and air inlet control cable (3).
  10. Disconnect the electrical connectors.

Installation Procedure


    2309282
  1. Connect the electrical connectors.
  2. Connect the temperature control cable (1), mode control cable (2) and air inlet control cable (3).
  3. Install the heater and A/C control (4) by gently inserting the heater and A/C control into the proper position on the I/P.
  4. Caution: Refer to Fastener Caution in the Preface section.


    2309274
  5. Install the heater and A/C control screws (1) and tighten to 2.5 N·m (23 lb in).
  6. Install the radio. Refer to Radio Replacement .
  7. Install the I/P compartment. Refer to Instrument Panel Compartment Replacement .
  8. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
   


© Copyright Chevrolet. All rights reserved