To the top of the document
Spark
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Crankshaft Position Sensor Replacement

Removal Procedure


    2327592
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Disconnect the crankshaft position sensor connector.
  3. Remove the crankshaft position sensor retaining bolt.
  4. Remove the crankshaft position sensor.

Installation Procedure


    2327592
  1. Install the crankshaft position sensor.
  2. Caution: Refer to Fastener Caution in the Preface section.

  3. Install the crankshaft position sensor retaining bolt and tighten to 6.5 N·m (7.5 lb in).
  4. Connect the crankshaft position sensor connector.
  5. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
   


© Copyright Chevrolet. All rights reserved