Spark

Oil Pressure Diagnosis and Testing

Special Tools

For equivalent regional tools, refer to Special Tools

1. Remove the oil pressure switch (1) using the EN-50207 oil pressure switch remover/installer .
2. Clean the thread.

1. Install the EN 50170-01 adapter oil pressure check (1) to the KM-498-B oil pressure gauge (2).
2. Install the EN 50170-01 adapter oil pressure check (1) with EN 498-B oil pressure gauge (2) to the oil pressure switch hole using the EN-50207 oil pressure switch remover/installer .
3. Start the engine.
4. Check oil pressure.

At idling speed, the oil pressure must be at least 110 kPa (15.95 psi) and the oil temperature must be less than or equal to 120°C (170°F).

1. Switch off the engine.
2. Remove the EN 50170-01 adapter oil pressure check (1) with EN 498-B oil pressure gauge (2) to the oil pressure switch hole using the EN-50207 oil pressure switch remover/installer.

Caution: Refer to Fastener Caution in the Preface section.

3. Install the oil pressure switch and tighten to 18 N·m (13 lb ft).
4. Check the engine oil level.