To the top of the document
Spark
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

DTC B0082

Diagnostic Instructions
    • Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
    • Review Strategy Based Diagnosis for an overview of the diagnostic approach.
    • Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptors

DTC B0082 01: Seat Belt Reminder Sensor Short to Battery

DTC B0082 02: Seat Belt Reminder Sensor Short to Ground

DTC B0082 04: Seat Belt Reminder Sensor Open Circuit

Diagnostic Fault Information

Circuit

Short to Ground

Open/High Resistance

Short to Voltage

Signal Performance

Seat Belt Reminder Sensor Signal

B0082 02

B0082 04

B0082 01

-

Seat Belt Reminder Sensor Ground

-

B0082 04

B0082 04

--

Circuit/System Description

The passenger seat belt reminder sensor is within the passenger seat cushion and provides an input to the inflatable restraint sensing and diagnostic module (SDM). The SDM supplies a low reference circuit and a seat belt reminder sensor signal circuit to determine seated or unseated condition of passenger seat.

Conditions for Running the DTC

Ignition voltage is between 9-16 V.

Conditions for Setting the DTC

B0082 01

The SDM detects a short to voltage in the seat belt reminder sensor signal circuit.

B0082 02

The SDM detects a short to ground in the seat belt reminder sensor signal circuit.

B0082 04

The SDM detects an open/high resistance in the seat belt reminder sensor signal circuit or the seat belt reminder sensor ground circuit.

Action Taken When the DTC Sets

The SIR System is disabled and no deployments are allowed.

Conditions for Clearing the DTC
    • The DTC will be current for as long as the fault is present.
    • When the fault is no longer present, the DTC will be a history DTC.
    • A history DTC will clear after 50 ignition cycles.

Reference Information

Schematic Reference

SIR Schematics

Connector End View Reference

Component Connector End Views

Description and Operation

SIR System Description and Operation

Electrical Information Reference

    •  Circuit Testing
    •  Testing for Intermittent Conditions and Poor Connections
    •  Wiring Repairs
    •  Connector Repairs

Scan Tool Reference

Control Module References for scan tool information

Circuit/System Verification
  1. Ignition ON, with the passenger seat unoccupied, verify the scan tool Passenger Seat Occupancy Status parameter is Empty Seat.
  2. With the passenger seat occupied, verify the scan tool Passenger Seat Occupancy Status parameter is Occupied.

Circuit/System Testing
  1. Ignition OFF, disconnect the harness connector at the B60 seat belt reminder sensor.
  2. Test for less than 30 Ω between the ground circuit terminal 2 and ground.
    3. ⇒If greater than the specified range, test the ground circuit for an open/high resistance. If the circuit tests normal, replace the K36 SDM.
  3. Ignition ON, test for 4.75-5.25 V between the signal circuit terminal 1 and ground.
    4. ⇒If less than the specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the K36 SDM.
    ⇒If greater than the specified range, test the signal circuit for a short to voltage. If the circuit tests normal, replace the K36 SDM.
  4. If all circuits test normal, replace the B60 seat belt reminder sensor.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.

    •  Driver or Passenger Seat Cushion Pad Replacement
    • Control Module References for SDM replacement, setup and programming
   


© Copyright Chevrolet. All rights reserved