Spark

Brake Pedal Assembly Replacement — Right Hand Drive

1. Remove the instrument panel (I/P) pad assembly. Refer to Instrument Panel Assembly Replacement .
2. Remove the I/P tie bar. Refer to Instrument Panel Tie Bar Replacement .



3. Disconnect the accelerator cable from the accelerator pedal by pulling and raising the cable end (1).



4. Lift up the cable end retaining spring (1) and disconnect the clutch cable (2) from the clutch pedal, if equipped. Refer to Clutch Cable Replacement .



5. Remove the retaining clip (1) and pin (2) from the brake pedal.
6. Release the brake booster pushrod from the brake pedal.



7. Remove the brake booster-to-accelerator, brake and clutch (ABC) pedal module retaining nuts (1) from the ABC pedal module.



8. Remove the ABC module-to-dash panel retaining nuts (1) from the ABC pedal module.
9. Remove the ABC pedal module from the vehicle.
10. Remove the accelerator pedal from the ABC pedal module, if necessary.

1. Install the accelerator pedal to the ABC pedal module, if necessary.
2. Install the ABC pedal module into the vehicle.

Caution: Refer to Fastener Caution in the Preface section.




3. Install the ABC module-to-dash panel retaining nuts (1) and tighten to 22 N·m (16 lb ft).



4. Loosely install the brake booster-to-ABC pedal module retaining nuts (1).



5. Connect the brake booster pushrod to the brake pedal.
6. Install the pushrod pin (2) to the brake pedal and insert the retaining clip (1) to the pin (2).



7. Completely tighten the brake booster-to-ABC pedal module retaining nuts (1) to 22 N·m (16 lb ft).
8. Connect the clutch cable to the clutch pedal, if equipped. Refer to Clutch Cable Replacement .
9. Connect the accelerator cable to the accelerator pedal.
10. Install the I/P pad assembly. Refer to Instrument Panel Assembly Replacement .
11. Install the I/P tie bar. Refer to Instrument Panel Tie Bar Replacement .