Spark

Instrument Cluster Programming and Setup

The instrument cluster does not need programming procedure such as the SPS.

If the instrument cluster is replaced as new one, the following procedures must be performed depending on odometer value of vehicle:

This procedure is needed when odometer value is higher than 100 km.

After replacing the instrument cluster, odometer value should be moved into new instrument cluster. On the scan tool select Odometer Programming. Follow the scan tool on screen instructions.

This procedure is needed when odometer value is lower than 100 km and new instrument cluster is not use odometer value stored in replaced instrument cluster.

On the scan tool select Odometer Reset. Follow the scan tool on screen instructions.