Operating Conditions: Ignition ON

Vehicle Speed

0 Km/h (0 MPH)

This parameter displays the speed of the vehicle as calculated by the transmission control module (TCM) from information received from the vehicle speed sensor (VSS).

Engine Speed

RPM

This parameter displays the rotational speed of the engine expressed as revolutions per minute.

Fuel Level Sensor

0-100% Varies

This parameter displays the amount of fuel remaining in the fuel tank as measured in percentage. The control module determines the amount of fuel remaining in the tank by using information from the fuel level sensors.

The scan tool will display a higher value with a full fuel tank, and a lower value with an empty fuel tank.

Engine Coolant Temperature

Varies

The scan tool displays C (F). This is the current engine coolant temperature.

Odometer

Varies

This parameter displays the vehicle mileage.

Trip Odometer A

Varies

This parameter displays the vehicle mileage stored in the trip A.

Trip Odometer B

Varies

This parameter displays the vehicle mileage stored in the trip B.

Manufacturer Enable Counter

-

-

AIR BAG Indication On/BLN

Off

The scan tool displays if the airbag warning indicator is illuminated.

ABS Indication On/BLN

Off

The scan tool displays if the ABS warning indicator is illuminated.

SEATBELT Indication On/BLN

Off

The scan tool displays if the driver seatbelt warning indicator is illuminated.

Module Diagnostic Address

Varies

The scan tool displays the Module Diagnostic Address.

ManufacturerTraceability Number

-

-

Software Part Number

Varies

The scan tool displays the boot Software Part Number.

End Model Part Number

Varies

This parameter displays the End Model Part Number.

Base Model Part Number

Varies

The scan tool displays the Base Model Part Number.

All Indicators

This function is used to command all the indicators ON or OFF.

Speedometer Gauge

This function is used to command the speedometer gauge to increase or decrease in 2 km/h increments.

Tachometer Gauge

This function is used to command the tachometer gauge to increase or decrease in 50 RPM increments.

Fuel Gauge

This function is used to command the fuel gauge to increase or decrease in 4% increments.

Driver Information Centre Segments

This function is used to command all the messages and indicators can be displayed in the cluster ON and OFF.

Odometer

This function is used to command the odometer to increase or decrease in 10 km increments.

Odometer A

This function is used to command the odometer stored in trip A to increase or decrease in 10 km increments. The distance is started from 0 km.

Odometer B

This function is used to command the odometer stored in trip B to increase or decrease in 10 km increments. The distance is started from stored distance in the trip.