To the top of the document
Spark
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Terminal Removal

Special Tools

    • EL-38125-550 Terminal Release Tool Kit
    • EL-35616 Terminal Test Probe Kit

For equivalent regional tools, refer to Special Tools .

Note: All repairs near the engine manifold, turbo engine and all exhaust pipes should follow the High Temperature Wiring Repair procedures.

  1. Find the appropriate connector end view within the connector end view section. The connector end view has the following information:
    2. • Diagnostic probe tool
    • Terminal release tool
    • Terminal/terminated lead part numbers

    Note: Not using the proper test kit probe may cause damage to the terminal(s) that are probed.

  2. Determine if a terminal is damaged.
    3. • Locate the diagnostic probe tool from the connector end view. The connector end view describes the colour and part number to help the technician find and use the correct tool.
    • Connect the probe tool to the Digital Multimeter.
    • Insert the probe tool into the cavity and follow the procedures from the Fault-finding with a Digital Multimeter.
  3. Disconnect the connector body to perform the repair.
  4. Use the following procedure to remove the terminal from the connector body.

    5. Note: Several procedures for specific connector bodies are called out in the Wiring Repairs section.

    • The terminal position assurance (TPA) and connector position assurance (CPA) should be removed before releasing the terminal for the connector body.
    • Look at the connector end view to locate the cavity of the damaged terminal and find the proper terminal release tool from the terminal release tool kit.

       Note: Using the incorrect terminal release tool can damage the connector body.

       Note: Some terminals have a lever that must be disengaged before the terminal can be released.

    • Insert the terminal release tool into the cavity.

    1774105
  5. Gently pull the wire out of the back of the connector.
  6. Repair the terminal by following the Repairing Connector Terminals : Terminal Repair → Terminated Lead Repair procedure.
  7. Insert the repaired terminal back into the cavity. Repeat the diagnostic procedure to verify the repair and reconnect the connector bodies.
   


© Copyright Chevrolet. All rights reserved