Spark

Fuel Injector Installation

Special Tools

For equivalent regional tools, refer to Special Tools .

1. Clean the injector sealing surfaces in the cylinder head, using the EN-47632 cleaning tool (1) in following procedure:

1.1.	Use the brush side to loosen the dirt.

1.2.	Use the sponge side to remove the dirt.




2. Install 3 NEW fuel injector gaskets (6) to camshaft housing.
3. Remove the EN-48559 protective caps from the Injector nozzles.
4. Install 3 NEW fuel injector seals (5).
5. Install 3 fuel Injectors (1) with 2 fuel injector brackets (4) and (7).
6. Install 2 fuel injector conical washer (3).

Caution: Refer to Fastener Caution in the Preface section.

7. Install 2 fuel injector nuts (2) and tighten with 25 N·m (18 lb ft).