Spark |
||||||||
|
|
Illustration | Tool Number/ Description |
---|---|
| EN-135 KM-135 Oil Pressure Gauge Adapter |
| EN-301 KM-301 Measuring Bridge |
| GE-328-B KM-328-B J-23907-1 or J-02619-A Remover Sliding Hammer |
| EN-470-B KM-470-B Torque Angle Sensor |
| GE-498-B KM-498-B CH-48027 J-21867-A Oil Pressure Gauge |
| GE-571-B MKM-571-B J-8001 Dial Gauge |
| EN-652 KM-652 Flywheel Holder |
| EN-662-C KM-662-C 8995063 Holding Spanner |
| CH-807 KM-807 Closure Plugs |
| EN-835-A KM-835-A Installer |
| EN-840 KM-840 J-36017 8394157 Pliers / Remover |
| CH-904 Base Frame |
| EN-956-1 KM-956-1 Extension |
| EN-37228 KM-J-37228 J-37228 5-8840-2153-0 Separation Tool |
| EN-45000 KM-J-45000 J-45000 Remover oil seal |
| EN-46775 Centring Tool (To adjust oil pump housing when installing) |
| EN-46777 Installer (To install the crankshaft rear oil seal ring) |
| EN-46783 Thread Adaptor, Compression Tool |
| EN-46785 Positioning Tool (Fix crankshaft transmission side, if transmission is installed) |
| EN-46786 32 025 13 Remover Injector in conjunction with EN-328-B |
| EN-46782 32 025 047 Adaptor, Compression Tool (includes EN-46783 thread adaptor) |
| EN-47632 32 025 010 Cleaner Injector Shaft |
| EN-48559 Injector Protective Caps |
| EN-48390 Remover / Installer Glow Plugs (For glow plugs with out pressure sensor) |
| CH-49290 Mounting Engine / Transmission |
| EN-50509 Fixing Tool |
| EN-50513 Locking Pin |
| EN-50514 Holder Camshaft |
| EN-50515 Fixing Tool |
| EN-50516 Fixing Tool Crankshaft |
| EN-50519 Fixing Tool Balance Shaft |
| EN-6015 KM-6015 Closure Plugs |
| EN-6368 KM-6368 Set of Plugs |
| EN-8087 J-8087 Cylinder Bore Gauge |
© Copyright Chevrolet. All rights reserved |