To the top of the document
Captiva
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Indicator Lamps and/or Indicators Inoperative

Step

Action

Yes

No

1

Did you perform the Diagnostic System Check - Vehicle?

Go to Step 2

Go to Diagnostic System Check - Vehicle

2

  1. Turn ON the ignition, with the engine OFF.
  2. Place the indicator stalk in the LEFT turn position.
  3. Place the indicator stalk in the RIGHT turn position.

Do the appropriate indicator lamps and/or indicators illuminate for each action?

Go to Testing for Intermittent Conditions and Poor Connections

Go to Step 3

3

Is only one indicator lamp inoperative?

Go to Step 6

Go to Step 4

4

Is only one of the indicator indicators inoperative?

Go to Step 5

Go to Step 7

5

Place the indicator stalk in the position of the inoperative indicator.

Does the test lamp illuminate and flash.

Go to Step 10

Go to Step 13

6

  1. Disconnect the inoperative indicator lamp.
  2. Probe the indicator supply voltage circuit of the inoperative lamp with a test lamp that is connected to a good ground.
  3. Place the indicator stalk in the position of the inoperative lamp.

Does the test lamp illuminate and flash?

Go to Step 14

Go to Step 15

7

Do the hazard lamps operate properly?

Go to Step 8

Go to Step 6

8

  1. Disconnect the indicator/hazard-headlamp switch.
  2. Probe the indicator flasher signal circuit with a test lamp that is connected to a good ground.

Does the test lamp illuminate and flash?

Go to Step 11

Go to Step 9

9

Test the indicator/flasher signal circuit for an open, high resistance, or short to ground.

Did you find and correct the condition?

Go to Step 19

Go to Step 12

10

Inspect for poor connections at the wiring harness plug of the IPC.

Did you find and correct the condition?

Go to Step 19

Go to Step 16

11

Inspect for poor connections at the wiring harness plug of the indicator/hazard-headlamp switch.

Did you find and correct the condition?

Go to Step 19

Go to Step 17

12

Inspect for poor connections at the wiring harness plug of the indicator/hazard-flasher.

Did you find and correct the condition?

Go to Step 19

Go to Step 18

13

Repair an open, high resistance, or short to ground in the inoperative indicator supply voltage circuit.

Did you complete the repair?

Go to Step 19

-

14

Repair an open or high resistance in the ground circuit of the inoperative lamp.

Did you complete the repair?

Go to Step 19

-

15

Repair an open, high resistance, or short to ground in the inoperative indicator supply voltage circuit.

Did you complete the repair?

Go to Step 19

-

16

Replace the IPC. Refer to Instrument Cluster Replacement : Long Body  → Short Body .

Did you complete the replacement?

Go to Step 19

-

17

Replace the indicator/hazard-headlamp switch.

Did you complete the replacement?

Go to Step 19

-

18

Replace the indicator/hazard-flasher.

Did you complete the replacement?

Go to Step 19

-

19

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 3

   


© Copyright Chevrolet. All rights reserved