To the top of the document
Captiva
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Crankshaft Balancer Removal

Special Tools

    • EN 38416-2 Crankshaft Button
    • EN 41816 Crankshaft Balancer Remover
    • EN 46106 Flywheel Holding Tool

For equivalent regional tools, refer to Special Tools .


    945978
  1. Install the EN 46106 through the starter mounting hole.

  2. 1864410
  3. Remove and discard the crankshaft balancer bolt.

  4. 1864555
  5. Install the EN 38416-2 button in the nose of the crankshaft.
  6. Install the EN 41816 remover in order to remove the crankshaft balancer.
  7. Tighten the centre bolt of the EN 41816 remover in order to pull the crankshaft balancer off of the crankshaft.
  8. Remove the EN 41816 remover from the crankshaft balancer.

  9. 945978
  10. Remove the EN 46106 tool.
   


© Copyright Chevrolet. All rights reserved