Captiva

Control Solenoid Valve and Transmission Control Module Assembly Programming and Setup — 6T30/6T40/6T45/6T50

The following service procedures require either a programming or a setup event performed for a complete repair. The transmission control module (TCM) is part of the control solenoid (w/body and TCM) valve assembly, and is not serviced separately.

If the TCM is replaced, the following procedures must be performed:

1. TCM Reprogramming
2. The Service Fast Learn Adapts -- Refer to Service Fast Learn Adapts

1. If the TCM needs to be reprogrammed, refer to Service Programming System (SPS) .
2. Perform the Service Fast Learn Adapts -- Refer to Service Fast Learn Adapts .

Note: After programming, perform the following to avoid future misdiagnosis:

1. Turn the ignition OFF for 30 seconds.
2. Turn the ignition ON with the engine OFF.
3. Use the scan tool in order to retrieve history DTCs from all modules.
4. Clear all history DTCs.

The replacement of some components will require a setup procedure for complete repair.

If any of the following components are replaced, the Service Fast Learn Adapts procedure must be performed:

Refer to Service Fast Learn Adapts .