To the top of the document
Captiva
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Powertrain Mount Balancing - Lower

Note: Follow the balancing procedure steps listed below. Powertrain mounts must be tightened in sequence.


    1810098
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Loosen the front transaxle mount through bolt.

  3. 1810114
  4. Loosen the rear transaxle mount through bolt.
  5. Shake the powertrain vigorously from front to rear and allow the powertrain to settle.
  6. Caution: Refer to Fastener Caution in the Preface section.


    1810114
  7. Tighten the rear transaxle mount through bolt to 100 N·m (74 lb ft).

  8. 1810098
  9. Tighten the front transaxle mount through bolt to 100 N·m (74 lb ft).
  10. Lower the vehicle.
   


© Copyright Chevrolet. All rights reserved