Captiva

Sump Cleaning and Inspection

Special Tools

EN 28410 Gasket Remover

For equivalent regional tools, refer to Special Tools

1. Remove any old thread sealant, gasket material or sealant using EN 28410 remover.
2. Clean the oil pan and oil pan components in solvent.
3. Clean out debris from the bolt holes.

Warning: Refer to Safety Glasses Warning in the Preface section.

4. Dry the oil pan and oil pan components with compressed air.

1. Inspect the exterior of the oil pan for the following conditions:

•	Dents or damage to the exterior (2)

•	Damage to the drain plug or drain plug hole (1)

•	Damage to the transaxle brace mounting bosses (4)

•	Damage to the transaxle mounting bosses (3)




2. Inspect the interior of the oil pan for the following conditions:

•	Gouges or damage to the sump seal surfaces (1)

•	Damage to the sump scraper mounting holes (2)

•	Damage to the bolt holes (3)

3. Repair or replace the oil pan and/or oil pan components as necessary.