To the top of the document
Captiva
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Blower Motor Resistor Replacement

Removal Procedure

    Warning: Refer to Battery Disconnect Warning in the Preface section.


    1760673

    Note: The left-hand drive is shown. The right-hand drive is similar.

  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Remove the instrument panel storage compartment. Refer to Instrument Panel Compartment Replacement : Long Body  → Short Body .
  3. Disconnect the electrical connector at the resistor.
  4. Remove the mount screws from the resistor.
  5. Remove the resistor from the heater/air distributor case by gently pulling the resistor downward.

Installation Procedure


    1760673
  1. Install the new resistor into the heater/air distributor case with the screws and tighten to 6 N·m (53 lb in).
  2. Connect the electrical connector at the resistor.
  3. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  4. Confirm the correct performance of the blower.
  5. Install the instrument panel storage compartment. Refer to Instrument Panel Compartment Replacement : Long Body  → Short Body .
   


© Copyright Chevrolet. All rights reserved