Transfer Case Input Shaft Seal - Left
Caution: Do not use a screwdriver or punch to remove or install the seal. Using a screwdriver or punch to remove or install the seal may damage the aluminium housing sealing surface.
Procedure
| • | Lightly lubricate the outer diameter (OD) of the seal with clean gear lube prior to installation. |
| • | To ensure proper alignment and depth of the seal, take four measurements every 90 degrees around the seal circumference, verifying uniform depth. The distance from the top face of the machined surface of the bore to the metal flange of the seal (A) should be 17.6 +/- 0.5 mm (0.693 +/- 0.02 in). Failure to follow these instructions will result in replacement seal failure. |
Tip
Alignment of seal is critical and use of correct tool is necessary. The machined surface of the bore must be clean and free from scratches or nicks.
Special Tools
| • | DT-48074 Input and Output Shaft Seal Installer |
| • | DT-26941/KM-J-26941 Bushing and Bearing Remover - 3-4 in |
| • | DT-45124 Removal Bridge |
For equivalent regional tools, refer to Special Tools
| 
