To the top of the document
Captiva
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Instrument Cluster Programming and Setup

The following service procedures require either a programming or a setup event performed for a complete repair. Do not reprogramme the mobile telephone control module, unless directed by a service procedure, or a service bulletin.

Instrument Cluster Replacement and/or Reprogramming

If the instrument cluster needs to be replaced and/or reprogrammed, the following procedures must be performed:

Programming the Odometer

  1. Connect a scan tool to the vehicle.
  2. Select Body, IPC (Instrument) then Programming.
  3. Select Program Odometer and follow the on-screen instructions.

Programming the Instrument Cluster

  1. Connect a scan tool to the vehicle and access SPS. Refer to Service Programming System (SPS) .
  2. Perform the SPS function Instrument Cluster - Programming and follow the on-screen instructions.
  3. Perform the SPS function Instrument Cluster - Configuration and follow the on-screen instructions.
  4. Perform the SPS function Instrument Cluster - Setup and follow the on-screen instructions.
  5. Clear DTCs after completing the programming procedure.
   


© Copyright Chevrolet. All rights reserved