Captiva

Sump Installation

1. Place a 3 mm (0.118 in) bead of RTV sealant on the block pan rail and the crankshaft rear oil seal housing (1). Refer to Adhesives, Fluids, Lubricants, and Sealers for recommended sealant.



2. Position the sump (1) onto the block.



3. Loosely install the sump bolts (1) and (2).

Caution: Refer to Fastener Caution in the Preface section.




4. Tighten the sump bolts in sequence shown.

4.1.	Tighten the 8 mm bolts (1-11) to 25 N·m (18 lb ft).

4.2.	Tighten the 6 mm bolts (12, 13) to 10 N·m (89 lb in).