Captiva

Brake Fluid Level Indicator Switch Replacement — LHD

1. Remove the underhood electrical center. Refer to Underhood Electrical Center or Junction Block Replacement .
2. Disconnect the brake fluid level indicator switch electrical connector.



3. While compressing the retaining tabs on the inboard side of the brake fluid level indicator switch (1), carefully remove the switch from the brake master cylinder reservoir.

Note: Ensure the retaining tabs on the brake fluid level indicator switch are fully engaged in the master cylinder reservoir.

1. Install the brake fluid level indicator switch (1) by carefully inserting the switch into the master cylinder reservoir.
2. Connect the brake fluid level indicator switch electrical connector.
3. Install the underhood electrical center. Refer to Underhood Electrical Center or Junction Block Replacement .