To the top of the document
Captiva
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Engine Support Fixture

Special Tools

    • EN-28467-B Universal Engine Support Fixture
    • EN-28467-13 Engine Support Fixture Adapter
    • EN-28467-34 Lift Hook Wing Nut and Washer
    • EN-36462-A Engine Support Adapter Leg Set
    • J-28467-6A Bracket Assembly
    • J-28467-7A Bolt Hook

For equivalent regional tools, refer to Special Tools : LE5 or LE9 .

Installation Procedure

  1. Remove the intake manifold cover. Refer to Intake Manifold Cover Replacement : LE5 or LE9 .
  2. Use M8 x 1.25 double-ended studs with 30 mm engagement to the damper tower and 16 mm engagement to the EN-28467-13 damper tower adapter.

  3. 1853722
  4. Install the EN-28467-13 adapter (1) and J-28467-5A front support assembly (2) to the top of the left and right strut tower.
  5. Install the J-28467-3 main support beam (3) transversely across the vehicle between both J-28467-5A front support assemblies .

  6. 1906669
  7. From the EN-28467-B fixture , install the J-28467-2A radiator shelf tube (1) on top of theJ-28467-3 strut tower tube (2) above the engine front (right back) lift hook bracket.
  8. Install the round tube of the J-28467-4A front support assembly (3) through the large hole in the J-28467-2A radiator shelf tube .
  9. Locate the J-28467-4A front support assembly to the upper tie bar.
  10. Install the J-28467-9 7/16 inch x 2.0 inch quick-release pin (4) through the top hole in the J-28467-4A front support assembly .

  11. 1906694
  12. Install the J-28467-1A cross bracket assembly (1).
  13. Hand-tighten the J-28467-1A cross bracket assembly wing nuts (2).

  14. 682139
  15. Install the J-28467-7A hook through the J-28467-6A assembly .
  16. Install the EN-28467-34 nut and washer to the J-28467-7A hook .
  17. Repeat the previous 2 steps in order to assemble 2 lift hooks and brackets.

  18. 1906671
  19. Install one of the lift hook and bracket assemblies (1) to the engine support fixture long bar (2).
  20. Install the other lift hook and bracket assembly (3) to the J-28467-2A radiator shelf tube (4) above the engine front lift bracket.

  21. 1906870
  22. Install the J-28467-7A hook through the engine rear lift bracket (2).

  23. 1906874
  24. Install the J-28467-7A hook (3) through the engine front lift bracket (4).
  25. Hand-tighten the EN-28467-34 nuts (5) in order to remove all slack from the engine support fixture assembly.
   


© Copyright Chevrolet. All rights reserved