To the top of the document
Captiva
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Fuel Tank Leak Test

Diagnostic Instructions

    • Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
    • Review Strategy Based Diagnosis for an overview of the diagnostic approach.
    • Diagnostic Procedure Instructions provides an overview of each diagnostic category.

Fuel Tank Leak Test

Warning: Place a dry chemical (Class B) fire extinguisher near the area before performing a Fuel Tank Leak Check. Before removing the fuel tank for a suspected leak, make sure that the fuel pipes or the tubes are not leaking onto the tank. Once removed, make sure that the fuel is not leaking around the fuel sender O-ring. Failure to follow these precautions may result in personal injury.

  1. Drain the fuel tank. Refer to Fuel Tank Draining
  2. Remove the fuel tank. Refer to Fuel Tank Replacement
  3. Plug the fuel feed hose, the fuel limiter vent valve hose, and the fuel tank vent valve hose on the fuel tank.
  4. Plug the fuel filler neck opening.
  5. Connect a piece of the hose to the breather hose nipple on the fuel tank and secure the hose with one clamp.
  6. Submerge the fuel tank in water or apply a soapy solution to the outside of the tank.
  7. Apply 7-15 kPa (1-2 PSI) air pressure to the breather hose.
  8. Air bubbles appearing from the fuel tank indicate a leak.
  9. If the fuel tank is leaking, replace the fuel tank.
   


© Copyright Chevrolet. All rights reserved