Service Information

Captiva

DTC P2534 - Fuel Pump Control Module

•	Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.

•	Review Strategy Based Diagnosis for an overview of the diagnostic approach.

•	Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC P2534: Ignition 1 Switch Circuit Low Voltage

Circuit	Short to Ground	Open\High Resistance	Short to Voltage	Signal Performance
IGN Voltage	P2534	P2534	-	-

The fuel pump control module monitors the ignition voltage circuit in order to determine if the voltage is within the normal operating range.

The engine is running.

The FPCM detects that the IGN voltage is less than 6.0 V.

DTC P2534 is a Type A DTC.

DTC P2534 is a Type A DTC.

Fuel System Description : LF1

•	Circuit Testing

•	Connector Repairs

•	Testing for Intermittent Conditions and Poor Connections

•	Wiring Repairs

Control Module References for scan tool information

⇒	If DTC P0562 is set, refer to Diagnostic Trouble Code (DTC) List - Vehicle .

Ignition OFF, disconnect the harness connector of the K27 fuel pump control module.
Ignition ON, verify that a test lamp illuminates between the ignition circuit terminal 15 and ground.

⇒	If the test lamp does not illuminate, test the ignition circuit for a short to ground or an open/high resistance.

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.

Control Module References for fuel pump control module replacement, programming and setup