Captiva

Cylinder Head Installation - LE5 or LE9

Special Tools

EN 45059 Angle Meter

For equivalent regional tools, refer to Special Tools : LE5 or LE9 .

Note: Do not use any sealing material.

1. Install the cylinder head gasket (2) to the block.
2. Install the cylinder head (1).

Caution: Refer to Fastener Caution in the Preface section.





Note: Always use new cylinder head bolts.

3. Install and tighten the cylinder head bolts in sequence.

•	Tighten the bolts to 30 N·m (22 lb ft).

•	Using the EN 45059 meter , tighten the bolts an additional 155 degrees in sequence.




4. Install the front cylinder head bolts (1) and tighten to 35 N·m (26 lb ft).