Captiva
Camshaft Cover Installation - LE5 or LE9
Install NEW camshaft cover grommets and camshaft cover bolts if they are serviced with the grommet.
Assemble the camshaft cover (1) with a NEW gasket. Ensure that the gasket is located in the retaining groove in the camshaft cover.
Caution:
Refer to
Fastener Caution
in the Preface section.
Install the cover on the cylinder head and hand start the bolts. Tighten the bolts to
10 N·m (89 lb in)
.
Install the front lift bracket (1).
Install the front lift bracket bolt and tighten to
25 N·m (18 lb ft)
.
Install the rear lift bracket (1).
Install the rear lift bracket bolts and tighten to
25 N·m (18 lb ft)
.
Install the ground strap (1) and tighten the bolts to
10 N·m (89 lb in)
.
Install the spark plugs (1) and tighten to
20 N·m (15 lb ft)
.
Install the ignition coil (1) and tighten the bolt to
10 N·m (89 lb in)
.
Install the camshaft position actuator solenoid valves (2).
Install the camshaft position actuator solenoid valve bolts and tighten to
10 N·m (89 lb in)
.
© Copyright Chevrolet. All rights reserved