To the top of the document
Captiva
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Range Selector Lever Cable Adjustment

Range Selector Lever Cable Adjustment

Important: The range selector lever cable must be disconnected from the transmission range selector lever prior to disconnecting it from the selector lever cable bracket. Otherwise damage to the manual shift shaft may result, requiring transmission disassembly.

    Note: Adjust the range selector lever cable while the transmission and the gear selector are in the Park position only. Failure to do so may cause mis-adjustment.

  1. Set the park brake and chock the wheels.
  2. Verify the transmission range selector lever is in the park position.
  3. Verify the transmission manual gear lever is in the park position.

  4. 2614013
  5. Disconnect the range selector lever cable terminal (1) from the transmission manual shift lever pin.
  6. Press the locking tabs inward in order to release the range selector lever cable (2) from the cable bracket.

  7. 2614056
  8. Release the range selector lever cable adjustment lock.
  9. Slide the black tab back.

  10. 2614084
  11. Insert a screwdriver into the slot under the white tab and pull up on the white tab.

  12. 2614013
  13. Install the range selector lever cable (2) to the cable bracket.
  14. Connect the range selector lever cable terminal (1) to the transmission manual shift lever pin.

  15. 2614067
  16. Lock the control cable adjustment tab.
  17. Push down on the white tab to secure in place

  18. 2614070
  19. Slide the black tab over the white tab to lock in place.
  20. Verify the proper operation.
   


© Copyright Chevrolet. All rights reserved