To the top of the document
Cruze
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Air Bag Indicator Circuit Malfunction - Driver

Diagnostic Instructions
    • Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
    • Review Strategy Based Diagnosis for an overview of the diagnostic approach.
    • Diagnostic Procedure Instructions provides an overview of each diagnostic category.

Circuit/System Description

When the ignition is turned ON, during the bulb check, the driver air bag indicator will flash, and then turn OFF after the bulb check. The inflatable restraint sensing and diagnostic module (SDM) performs diagnostic tests on the SIR system during the bulb check. If any malfunction exists the SDM will request the instrument cluster to illuminate the air bag indicator steady, via serial data. If a preexisting malfunction exists, the air bag indicator will illuminate steady immediately after the ignition is turned ON. If the ignition 1 voltage is outside of the normal operating voltage range of 9-16 V, the SDM will command the instrument cluster to illuminate the air bag indicator ON, even with no DTCs present, and then disable all deployment loops.

Diagnostic Aids
    • A DTC B1370 may set if the ignition 1 circuit is outside the 9-16 V range.
    • A flashing driver air bag indicator is displayed if the inflatable restraint sensing and diagnostic module was programmed but did not fully complete the programming. For a flashing driver airbag indicator, refer to Inflatable Restraint Sensing and Diagnostic Module Programming and Setup .

Reference Information

Schematic Reference

SIR Schematics

Connector End View Reference

Component Connector End Views

Description and Operation

SIR System Description and Operation

Electrical Information Reference

    •  Circuit Testing
    •  Testing for Intermittent Conditions and Poor Connections
    •  Connector Repairs
    •  Wiring Repairs

Scan Tool Reference

Control Module References for scan tool information

Circuit/System Verification

If the driver air bag indicator is flashing, refer to Inflatable Restraint Sensing and Diagnostic Module Programming and Setup .

Circuit/System Testing
  1. Verify SDM DTCs are not set.
    2. [ARW-LISTFAIL]

  2. If SDM DTCs are set

    Refer to Diagnostic Trouble Code (DTC) List - Vehicle .

    3. [/ARW-LISTFAIL][ARW-LISTPASS]

  3. If SDM DTCs are not set

    4. [/ARW-LISTPASS]
  4. With a scan tool command the Instrument Cluster to turn all instrument cluster indicators ON and OFF. The air bag indicator should turn ON and OFF as commanded.
    5. [ARW-LISTFAIL]

  5. If air bag indicator does not turn on or off

    If the air bag indicator does not turn ON and OFF as expected, replace the P16 instrument cluster.

    6. [/ARW-LISTFAIL][ARW-LISTPASS]

  6. If air bag indicator does turn on or off

    7. [/ARW-LISTPASS]
  7. Replace the K36 SDM.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.

    •  SIR/SRS Wiring Repairs
    • Control Module References for instrument cluster or SDM replacement, programming and setup
   


© Copyright Chevrolet. All rights reserved