Cruze

Intake Air Pressure and Temperature Sensor Replacement

1. Remove the engine cover. Refer to Engine Cover Replacement .
2. Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .



3. Disconnect the fuel pressure sensor wiring harness plug (1) from the fuel rail.
4. Disconnect the intake air temperature sensor wiring harness plug (3).
5. Unclip the wiring harness channel (4) from the 2 brackets (2).



6. Remove the intake air temperature sensor bolt (2).
7. Remove the intake air temperature sensor (1) from the intake manifold (3).

Caution: Refer to Fastener Caution in the Preface section.




1. Install the intake air temperature sensor bolt (2) and tighten to 8 N·m (71 lb in).
2. Install the intake air temperature sensor (1) at the intake manifold (3).



3. Clip the wiring harness channel (4) at the 2 brackets (2).
4. Connect the intake air temperature sensor wiring harness plug (3).
5. Connect the fuel pressure sensor wiring harness plug (1) at the fuel rail.
6. Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
7. Install the engine cover. Refer to Engine Cover Replacement .