Cruze

Crankshaft Position Sensor Replacement

1. Open the hood.
2. Disconnect the crankshaft position sensor wiring harness plug.
3. Raise the vehicle by its full height. Refer to Lifting and Jacking the Vehicle .



4. Remove the crankshaft position sensor bolt (2).
5. Remove the crankshaft position sensor (1).

1. Install the crankshaft position sensor (1).

Caution: Refer to Fastener Caution in the Preface section.

2. Install the crankshaft position sensor bolt (2) and tighten to 10 N·m (89 lb in).
3. Lower the vehicle by its full height.
4. Connect the crankshaft position sensor wiring harness plug.
5. Close the hood.