Cruze

Knock Sensor Replacement

1. Open the hood.
2. Disconnect the knock sensor wiring harness plug.
3. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
4. Remove the starter. Refer to  Starter Replacement



5. Remove the knock sensor bolt (1).
6. Remove the knock sensor (2).

1. Install the knock sensor (2).

Caution: Refer to Fastener Caution in the Preface section.

2. Install the knock sensor bolt (1) and tighten to  20 N·m (15 lb ft).
3. Install the starter. Refer to  Starter Replacement
4. Lower the vehicle.
5. Connect the knock sensor wiring harness plug.
6. Close the hood.