Service Information

Cruze

Evaporative Emission Canister Purge Solenoid Valve Replacement - 1.8L 2H0

Callout

Component Name

Evaporative Emission Feed Hose

Warning: Petrol or petrol vapours are highly flammable. A fire could occur if an ignition source is present. Never drain or store petrol or diesel fuel in an open container, due to the possibility of fire or explosion. Have a dry chemical (Class B) fire extinguisher nearby.

Warning: In order to reduce the risk of fire and personal injury observe the following items:

•	Replace all nylon fuel pipes that are nicked, scratched or damaged during installation, do not attempt to repair the sections of the nylon fuel pipes

•	Do not hammer directly on the fuel harness body clips when installing new fuel pipes. Damage to the nylon pipes may result in a fuel leak.

•	Always cover nylon vapor pipes with a wet towel before using a torch near them. Also, never expose the vehicle to temperatures higher than 115°C (239°F) for more than one hour, or more than 90°C (194°F) for any extended period.

•

Apply a few drops of clean engine oil to the male pipe ends before connecting fuel pipe fittings. This will ensure proper reconnection and prevent a possible fuel leak. (During normal operation, the O-rings located in the female connector will swell and may prevent proper reconnection if not lubricated.)

Evaporative Emission Return Hose

Evaporative Emission Canister Purge Solenoid Valve

Procedure

Disconnect the electrical connector

Tip
Install the evaporative emission canister purge valve with the arrow in the direction of the evaporative emission feed hose.