Cruze |
||||||||
|
|
|
|||||||
| Table 1: | Instrument Cluster Scan Tool Data Parameters |
| Table 2: | Instrument Cluster Scan Tool Output Controls |
Parameter | Expected Value | Description |
|---|---|---|
Operating Conditions: Ignition ON | ||
Battery Voltage | 12-14 V | The scan tool displays Volts. This is the current battery voltage signal. |
Key in Ignition Status | Active/Inactive | The scan tool displays Active or Inactive. This is the state of the key in ignition switch. |
Driver Information Centre Switch | Varies | The scan tool displays Volts. This is the current driver information centre switch input voltage. |
Driver Information Centre Switch | Inactive | The scan tool displays either Inactive, Up, Down, or Menu. This is the state of the driver information centre switch. |
Reset Switch | Active/Inactive | The scan tool displays Active or Inactive. This is the state of the reset switch. |
Ambient Air Temperature | 15°C | The scan tool displays outside temperature in °C. |
Washer Fluid Level Switch | Open | The scan tool displays either Open, Closed, or Not Available. |
Odometer Lock Status | Active/Inactive | The scan tool displays Active or Inactive depending on the state of the odometer. |
Engine Speed | 0 RPM | The scan tool displays the filtered value of engine speed. |
Vehicle Speed | 0 km/h | The scan tool displays the filtered vehicle speed value. |
Fuel Level Sensor | -- | The scan tool displays the filtered value of the fuel level. |
Engine Coolant Temperature | -- | The scan tool displays the filtered value of the engine coolant temperature. |
Engine Oil Pressure | - | The scan tool displays the filtered value of the engine oil pressure. |
Output Control | Description |
|---|---|
Instrument Cluster Gauge Sweep | This function is used to command the gauges to sweep from minimum to maximum. |
Driver Information Centre Dimming | This function is used to command the dimming of the driver information display to Increase or Decrease by 10%. |
Instrument Panel Dimmer Switch | This function is used to command the dimming of the instrument cluster to Increase or Decrease by 10%. |
Driver Information Centre Segments | This function is used to command the driver information centre segments ON and OFF. |
All Indicators | This function is used to command all the indicators ON or OFF. |
Driver Information Centre Options | This function is used to command the driver information centre buttons using the scan tool. |
Odometer Programming | This function is used to command the odometer to reset. |
CAN Bus Configuration Learn | This function is used to Reset the source ID for low speed CAN Bus communications. |
| © Copyright Chevrolet. All rights reserved |
