Cruze

Exhaust Camshaft Installation

Special Tools

For equivalent regional tools refer to Special Tools .

1. The exhaust camshaft secondary gear (2) has to be pretensioned. Use the EN-6092 adjuster  (1) to pretension the secondary gear and use EN-6092-10 fixing tool  (4) to fix with the exhaust camshaft gear (3).

Note: Lubricate the camshaft with engine oil.

2. Install the exhaust camshaft.



3. The marks in the intake camshaft gear (2) must align with the marks in the exhaust camshaft gear (1).




Note: Lubricate the camshaft bearing caps with engine oil.

4. Install the 4 camshaft bearing caps.
5. Install the 4 camshaft bearing cap bolts (1) and the 8 camshaft bearing cap nuts (2).



6. Tighten the 4 camshaft bearing cap bolts and nuts in a sequence as shown and in increments of 1 or 2 turns at a time until they are seated.

Caution: Refer to Fastener Caution in the Preface section.

7. Tighten the camshaft bearing cap bolts and nuts to 27N·m(20 lb ft).
8. Remove EN-6092-10 fixing tool .




Note: Lubricate the camshaft bearing front cap with engine oil.

9. Install the camshaft bearing front cap (3).
10. Install the camshaft bearing front cap bolt (1) and the 2 camshaft bearing front cap nuts (2) and tighten to 27N·m(20 lb ft).