Service Information

Cruze

Adding Keys - with BTM

Note:

•	This procedure may be used with or without existing learned keys being present.

•	This procedure will take more than 15 minutes to complete.

•	A total of 8 keys maybe be learned to a single vehicle.

•	This procedure will only learn the vehicle key information. This procedure will not learn any immobiliser information between the body control module (BCM) and engine control module (ECM).

•	If the battery voltage is low, charge the battery before continuing with the procedure.

Connect a scan tool to the vehicle and access SPS. Refer to Service Programming System (SPS) .
Ensure that all power consuming devices are turned OFF on the vehicle.
Select the SPS application and follow the onscreen instructions.
Select Reprogram ECU.
Select IMMO Immobiliser Learn.
Select the Program Transponder & Remote Key function.

Note:

•	At multiple times during the learn procedure, SPS will instruct you to turn the ignition to the run position. Make sure the vehicle is actually in the run mode before continuing on the SPS terminal. If the igniting is not in the run mode, the learn procedure will fail.

•	The key pocket is located inside the centre console storage area under the cupholder. The cupholder will need to be removed to access the key pocket.

•

The key must be placed flat in the pocket with the buttons facing up and the keyring on the right. If a large keyring prevents the key from laying flat in the pocket, remove the keyring and place the key in the pocket. Failure to position the key flat in the pocket will result in an inability to program.

Follow the on-screen instructions.
After the SPS procedure has completed, press and hold the ignition mode switch for 15 seconds.
With a scan tool, clear any DTCs.