To the top of the document
Cruze
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Water Pump Pulley Replacement - 2.0L Diesel LNP

Special Tools

EN-46104 Water Pump Pulley Holding Tool

For equivalent regional tools, refer to Special Tools .

Removal Procedure

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the engine compartment insulator. Refer to Front Compartment Insulator Replacement .
  3. Remove the right front wheelhousing lining. Refer to Front Wheelhouse Liner Replacement .
  4. Remove the drive belt and pulley cover. Refer to Drive Belt and Pulley Cover Removal .
  5. Remove the drive belt. Refer to Drive Belt Replacement .

  6. 2373164
  7. Counterhold the water pump pulley with the EN-46104 holding tool and remove the 3 water pump pulley bolts (2).
  8. Remove the water pump pulley (1).

Installation Procedure


    2373164
  1. Install the water pump pulley (1).
  2. Install the water pump pulley bolts (2).
  3. Caution: Refer to Fastener Caution in the Preface section.

  4. Counterhold the water pump pulley with the EN-46104 holding tool and tighten the bolts (2) to 18 N·m (13 lb ft).
  5. Install the drive belt. Refer to Drive Belt Replacement .
  6. Install the drive belt and pulley cover. Refer to Drive Belt and Pulley Cover Installation .
  7. Install the right front wheelhousing lining. Refer to Front Wheelhouse Liner Replacement .
  8. Install the engine compartment insulator. Refer to Front Compartment Insulator Replacement .
  9. Lower the vehicle.
   


© Copyright Chevrolet. All rights reserved