Warning : When a tailgate hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the vehicle or personal injury.

1

Tailgate Hinge Bolt (Qty: 4)

Caution : Refer to Fastener Caution in the Preface section.

Tighten
22 N·m (16 lb ft)

Procedure

With the aid of an assistant, remove the tailgate.

2

Liftgate

Procedure

Warning : Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.

For Vehicles equipped with OnStar® (UE1) with Back Up Battery :
The Back Up Battery is a redundant power supply to allow limited OnStar® functionality in the event of a main vehicle battery power disruption to the VCIM (OnStar®module). Do not disconnect the main vehicle battery or remove the OnStar® fuse with the ignition key in any position other than OFF. Retained accessory power (RAP) should be allowed to time out or be disabled (simply opening the driver door should disable RAP) before disconnecting power. Disconnecting power to the OnStar® module in any way while the ignition is On or with RAP activated may cause activation of the OnStar® Back-Up Battery (BUB) system and will discharge and permanently damage the back-up battery. Once the Back-Up Battery is activated it will stay on until it has completely discharged. The BUB is not rechargeable and once activated the BUB must be replaced.
1. Disconnect the battery. Refer to Battery Negative Cable Disconnection and Connection .
2. Disconnect electrical connectors as needed.
3. Transfer all of the internal components.
4. Adjust the tailgate as needed. Refer to Liftgate Adjustment .