To the top of the document
Orlando
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Relay Replacement - Attached to Wire Harness

Removal Procedure


    791846
  1. Locate the relay. Refer to the Master Electrical Component List to locate the relay in the vehicle.
  2. Remove any fasteners which hold the relay in place.
  3. Remove any connector position assurance (CPA) devices or secondary locks.
  4. Note: Use care when removing a relay in a wiring harness when the relay is secured by fasteners or tape.

  5. Separate the relay (1) from the wire harness connector (2).

Installation Procedure


    791846
  1. Connect the relay (1) to the wire harness connector (2).
  2. Install any connector position assurance (CPA) devices or secondary locks.
  3. Install the relay using any fasteners or tape that originally held the relay in place.
   


© Copyright Chevrolet. All rights reserved