To the top of the document
Orlando
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Dual Phase Steel

This information provides repair recommendations and general guidelines for steel classified as Dual Phase Steel (Dual Phase Steel with a tensile strength up to and including 800 MPa), also known as DP.

General Motors recommends the following when repairing or replacing this type of steel during collision repair.

Note :  The use of heat to repair damage is not recommended for this classification of steel.

Recommended Repairs

    • Cold repairs can be performed on this type of steel, unless the damage includes kinks. If the damage includes kinks, the part should be replaced.
    • Sectioning or partial replacement of this type of steel is recommended only at approved locations, in a specific sectioning procedure.
    • This type of steel can be used as a sleeve, or backer plate, when recommended in a specific sectioning procedure.
    • Squeeze Resistance Spot Welding can be used to replace factory spot welds, where applicable.
    • MIG plug welding and MIG stitch welding can be used on this type of steel.
    • MIG Brazing can be used on this type of steel.
   


© Copyright Chevrolet. All rights reserved