To the top of the document
Orlando
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Ultra High Strength Dual Phase Steel

This information provides repair recommendations and general guidelines for steel classified as Ultra High Strength Dual Phase Steel (Dual Phase Steel with a tensile strength greater than 800 MPa), also known as DPX.

General Motors recommends the following when repairing or replacing this type of steel during collision repair.

Note : 

   • Repair of this type of steel is not recommended.
   • This type of steel should be replaced at factory joints only. Sectioning or partial replacement is not recommended.
   • The use of heat to repair damage is not recommended for this type of steel.
   • Stitch Welding is not recommended for this type of steel.
   • This classification of steel can not be used as a backing reinforcement or a sleeve for a sectioning joint, unless a specific procedure is available.

Recommended Repairs:

    • Squeeze Resistance Spot Welding can be used to replace factory spot welds, where applicable.
    • MIG plug welding can be used to replace factory spot welds.
    • MIG Brazing can be used to replace factory spot welds.
   


© Copyright Chevrolet. All rights reserved