Orlando |
||||||||
|
|
|
|||||||
| Table 1: | Fuel Pump Flow Control Module Scan Tool Data Parameters |
| Table 2: | Fuel Pump Flow Control Module Scan Tool Output Controls |
Parameter | System State | Expected Value | Description |
|---|---|---|---|
Operating Conditions: Ignition ON/Engine Idling at Normal Operating Temperature / Vehicle is in Park or Neutral | |||
Desired Fuel Rail Pressure | -- | 306.8 kPa (44.5 psi) | This displays kPa (psi). This is the desired fuel rail pressure. |
Fuel Pump Command | -- | On | The scan tool displays On or Off. This is the current state of the fuel pump command. |
Fuel Pump Signal Command | -- | Varies | This displays %. This is the commanded fuel pump signal measured in percentage. |
Fuel Rail Pressure Sensor | -- | 296.4-310.3 kPa (43-45 psi) | This displays kPa (psi). This is the current pressure at the fuel rail pressure sensor. |
Fuel Rail Pressure Sensor | -- | 4.90-5.01 Volts | This displays Volts. This is the fuel rail pressure sensor voltage. |
Ignition 1 Signal | -- | Varies | This displays Volts. This is the current ignition 1 signal. |
LT Fuel Pump Trim | -- | Varies | This displays a numeric value. This is the long term (LT) fuel pump trim. |
ST Fuel Pump Trim | -- | Varies | This displays a numeric value. This is the short term (ST) fuel pump trim. |
Output Control | Description |
|---|---|
Fuel Pressure Control | This output control is used to control the fuel pressure. |
Fuel Pump | This output control is used to command the fuel pump ON and OFF. |
Fuel Pump Trim Reset | This output control is used to reset the fuel pump trim. |
| © Copyright Chevrolet. All rights reserved |
