To the top of the document
Orlando
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Transmission Case Cleaning and Inspection


1891324

Callout

Component Name

Caution: Do not use abrasive pads or bristle devices to clean the sealing surfaces. Abrasive pads produce a fine grit that can effect transmission function. Abrasive pads can also remove enough metal to create oil leaks.

Caution: After cleaning the transmission components, allow to air dry. Do not use cloth or paper towels in order to dry any transmission components. Lint from the towels can cause component failure.

Caution: Do not reuse cleaning solvents. Previously used solvents may deposit sediment which may damage the component.

Preliminary Procedures

  1. Thoroughly clean the transmission case assembly, including case threads, with clean solvent.
  2. Clean gasket sealing surfaces. Remove all residual gasket material.
  3. Inspect all threaded holes. If necessary, repair any thread damage.

1

Torque Converter Housing Locating Pin

Procedure

Inspect the torque converter housing locating pins.

Tip
The locating pins installed height is 7.4 mm (0.29 in).

2

Fluid Trough Check Ball

Tip
The check ball installed depth is 11 mm (0.43 in).

3

Converter Housing Sealing Surface

4

Control Valve Body Cover Sealing Surface

5

Fill Cap Seal

6

Transmission Fluid Cooler Pipe Sealing Surface

7

Fluid Pressure Test Plug

Caution: Refer to Fastener Caution in the Preface section.

Tighten
12 N·m (106 lb in)

8

Manual Shift Shaft Seal Surface

9

Fluid Fill Cap Sealing Surface

10

Fluid Level Plug

Tighten
12 N·m (106 lb in)

11

Valve Body Locating Pin

Procedure

Inspect the valve body locating pins.

Tip
The locating pins installed height is 5.8 mm (0.22 in).

12

Drain Plug

Tighten
12 N·m (106 lb in)

   


© Copyright Chevrolet. All rights reserved