Orlando

Crankshaft and Bearing Installation

Special Tools

EN-45059 Torque Angle Sensor Kit

For equivalent regional tools, refer to Special Tools

Note: Inspect the installation position.

1. Install the crankshaft bearing clips, oil bearing clips.
2. Install the crankshaft.

Note: Inspect the installation position.

3. Install the crankshaft bearing caps 1-4.

•	Oil bearing clips.

•	Install the 8 NEW crankshaft bearing cap bolts.

Note: Inspect the installation position.

4. Install the crankshaft bearing cap.

4.1.	Apply black adhesive sealing compound to the grooves of the rear crankshaft bearing cap.

4.2.	Install the 2 NEW crankshaft bearing cap bolts.

Caution: Refer to Fastener Caution in the Preface section.

Caution: Refer to Torque-to-Yield Fastener Caution in the Preface section.




5. Tighten the bolts for the crankshaft bearing caps (1) in 3 passes using the EN-45059 sensor kit:

•	First pass to 50 N·m (37 lb ft)

•	Second pass to 45°

•	Third pass to 15°





Note: Inspect the installation position.

6. Install the connecting rod bearing caps 2 and 3 (1) and oil the bearing clips.
7. Install 4 NEW connecting rod bearing cap bolts and tighten in 3 passes use the EN-45059 sensor kit:

•	First pass to 35 N·m (26 lb ft)

•	Second pass to 45°

•	Third pass to 15°




8. Turn the crankshaft through 180°.

Note: Inspect the installation position.

9. Install the connecting rod bearing caps 1 and 4 (1) and oil the bearing clips.
10. Install 4 NEW connecting rod bearing cap bolts and tighten in 3 passes use the EN-45059 sensor kit:

•	First pass to 35 N·m (26 lb ft)

•	Second pass to 45°

•	Third pass to 15°