Orlando

Front Disc Brake Pads Replacement

Special Tools

CH-6007-B Disc Brake Piston Installation Tool

For equivalent regional tools, refer to Special Tools .

Warning: Refer to Brake Dust Warning in the Preface section.

Warning: Refer to Brake Fluid Irritant Warning in the Preface section.

1. Inspect the fluid level in the brake master cylinder reservoir.
2. If the brake fluid level is midway between the maximum-full point and the minimum allowable level, no brake fluid needs to be removed from the reservoir before proceeding.
3. If the brake fluid level is higher than midway between the maximum-full point and the minimum allowable level, remove brake fluid to the midway point before proceeding.
4. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
5. Remove the tyre and wheel assembly. Refer to Tyre and Wheel Removal and Installation .



6. Remove the brake calliper lower guide pin bolt (2).
7. Without disconnecting the hydraulic brake flexible hose, pivot the calliper (1) upward and secure the calliper with heavy mechanics wire, or equivalent.



8. Remove the brake pads (1) from the calliper mounting bracket.



9. Push the disc brake caliper piston (1) into the caliper bore using the CH-6007-B installation tool .



10. Remove the brake pad retainer springs (1) from the calliper bracket.
11. Thoroughly clean the brake pad hardware mating surfaces of the calliper bracket of any debris and corrosion.
12. Inspect the brake calliper guide pins for freedom of movement and inspect the condition of the guide pin boots. Move the guide pins inboard and outboard within the bracket bores, without disengaging the slides from the boots, and observe for the following:

•	Restricted calliper guide pin movement

•	Looseness in the brake calliper mounting bracket

•	Seized or binding calliper guide pins

•	Split or torn boots

13. If any of the conditions listed are found, the brake calliper guide pins and/or boots require replacement.

1. Ensure the brake pad hardware mating surfaces are clean.
2. Install the brake pad retainer springs (1) to the brake calliper bracket.

Apply a thin coat of high temperature silicone lubricant to the brake pad retainers.





Note: The wear sensor equipped disc brake pad must be mounted inboard of the rotor with the leading edge of the sensor facing the brake rotor during forward wheel rotation, or at the top of the pad when installed in vehicle position.

3. Install the brake pads (1) to the calliper bracket.
4. Remove the support, and rotate the brake calliper into position over the disc brake pads and to the calliper mounting bracket.

Caution: Refer to Fastener Caution in the Preface section.

5. Install the lower brake calliper guide pin bolt and tighten to 28 N·m (21 lb ft).
6. Install the tyre and wheel assembly. Refer to Tyre and Wheel Removal and Installation .
7. Lower the vehicle.
8. With the engine OFF, gradually apply the brake pedal approximately 2/3 of its travel distance.
9. Slowly release the brake pedal.
10. Wait 15 seconds, then gradually apply the brake pedal approximately 2/3 of its travel distance again until a firm brake pedal apply is obtained. This will properly seat the brake calliper pistons and brake pads.
11. Fill the master cylinder auxiliary reservoir to the proper level. Refer to Master Cylinder Reservoir Filling .