Orlando

Camshaft Cover Replacement — 1.6L LDE, LXV, 1.8L 2H0, LUW and LFH

1. Open the bonnet.
2. Remove the ignition coil. Refer to Ignition Coil Replacement .



3. Unclip the ECM wiring harness guide (1) from the cylinder head cover.
4. Disconnect the wiring guide (2).
5. Remove the positive crankcase ventilation tube. Refer to Positive Crankcase Ventilation Hose/Pipe/Tube Replacement : 1.6L LDE, LXV, 1.8L 2H0, LUW and LFH .



6. Remove the 11 bolts (2, 3).
7. Remove the camshaft cover (1).

1. Install the camshaft cover (1).

Insert a NEW gasket in the cylinder head cover.

Caution: Refer to Fastener Caution in the Preface section.

2. Install the 11 bolts (2, 3) and tighten to 8 N·m (71 lb in).
3. Install the positive crankcase ventilation tube. Refer to Positive Crankcase Ventilation Hose/Pipe/Tube Replacement : 1.6L LDE, LXV, 1.8L 2H0, LUW and LFH .



4. Clip in the ECM wiring harness guide (1) to the cylinder head cover.
5. Connect the wiring guide (2).
6. Install the ignition coil. Refer to Ignition Coil Replacement .
7. Close the bonnet.