To the top of the document
Orlando
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Steering Knuckle Replacement


2028303

Callout

Component Name

Preliminary Procedures

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the wheel bearing and hub assembly. Refer to Front Wheel Bearing and Hub Replacement .
  3. Separate the outer track rod end from the knuckle. Refer to Steering Linkage Outer Track rod Replacement .
  4. Separate control arm ball joint from steering knuckle. Refer to Lower Control Arm Replacement .

1

Steering Knuckle Bolt (Qty: 2)

2

Steering Knuckle Nut (Qty: 2)

Warning: Refer to Torque-to-Yield Fastener Warning in the Preface section.

Caution: Refer to Fastener Caution in the Preface section.

Procedure

  1. Install NEW nuts. Do NOT reuse old nuts.
  2. Use EN-45059 angle meter to apply torque.

Tighten
90 N·m (66 lb ft) + 60-70 degrees

Special Tools

EN-45059 Torque Angle Sensor Kit

For equivalent regional tools, refer to Special Tools .

3

Steering Knuckle

   


© Copyright Chevrolet. All rights reserved