To the top of the document
Orlando
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Inflatable Restraint Side Impact Sensor Replacement


2027731

Callout

Component Name

Warning: Refer to SIR Warning in the Preface section.

Warning: Refer to SIR Inflator Module Handling and Storage Warning in the Preface section.

Warning: Following the deployment of a side impact air bag, inspect the following parts for damage. Replace these parts if necessary:

   • The seat cushion frame
   • The seat recliner, if equipped
   • The seat adjuster
   • The seat back frame
Failure to do so may cause future personal injury.

Preliminary Procedures

  1. Disable the SIR system. Refer to SIR Disabling and Enabling .
  2. Remove the central pillar lower trim moulding. Refer to Centre Pillar Lower Garnish Moulding Replacement .

1

Inflatable Restraint Side Impact Sensor Screw

Caution: Refer to Fastener Caution in the Preface section.

Tighten
7.5 N·m (66 lb in)

2

Inflatable Restraint Side Impact Sensor

Procedure

  1. Disconnect electrical connector.
  2. Loosen the bolts and slide the sensor out of the keyhole slots.

Tip
The bolt is integral to the sensor assembly, DO NOT remove separately.

   


© Copyright Chevrolet. All rights reserved