1

Heated Oxygen Sensor 2

Warning: In order to avoid being burned, do not service the exhaust system while it is still hot. Service the system when it is cool.

Caution: Refer to Fastener Caution in the Preface section.

Procedure

1. Disconnect the heated oxygen sensor 2 wiring harness plug.
2. Remove the heated oxygen sensor 2.
3. When re-using the heated oxygen sensor, coat the thread with assembly paste.

Tighten
40 N·m (30 lb ft)

Special Tools

EN-6179 Heated Oxygen Sensor Remover / Installer

For equivalent regional tools, refer to Special Tools .