Lights On Indicator Malfunction
Diagnostic Instructions
Circuit/System Description
With the headlamp switch in the HEADLAMP or PARKLAMP position, the appropriate headlamp switch signal circuit is grounded through the headlamp switch. The body control module (BCM) then sends a serial data message to the instrument cluster requesting the instrument cluster to illuminate the lights on indicator. With the indicator/multifunction switch in the MAIN BEAM or FLASH TO PASS position the appropriate indicator/multifunction switch signal circuit is grounded through the indicator/multifunction switch. The BCM then sends a serial data message to the instrument cluster requesting the instrument cluster to illuminate the main beam indicator. The BCM will also request the instrument cluster to turn on the LIGHTS ON INDICATOR located in the driver information centre anytime the headlamps are ON and the ignition is OFF or the driver door is opened.
Diagnostic Aids
This diagnostic procedure assumes that the headlamps operate as described in Exterior Lighting Systems Description and Operation .
Reference Information
Schematic Reference
Connector End View Reference
Component Connector End Views
Description and Operation
Exterior Lighting Systems Description and Operation
Electrical Information Reference
Scan Tool Reference
Control Module References for scan tool information
Circuit/System Testing
Lights On Indicator Malfunction
Ignition ON, command the All Indicators test ON and OFF with the scan tool, verify that the lights on indicator changes between turn ON and OFF.
| ⇒ | If the lights on indicator does not illuminate during the test or remains illuminated at all times, replace the P16 Instrument Cluster. |
| ⇒ | If the lights on indicator illuminates during the test, replace the K9 Body Control Module. |
Main Beam Indicator Malfunction
Ignition ON, command the All Indicators test ON and OFF with the scan tool, verify that the main beam indicator changes between turn ON and OFF.
| ⇒ | If the main beam indicator does not illuminate during the test or remains illuminated at all times, replace the P16 Instrument Cluster. |
| ⇒ | If the main beam indicator illuminates during the test, replace the K9 Body Control Module. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for BCM or instrument cluster replacement, setup, and programming
| © Copyright Chevrolet. All rights reserved |
