Orlando

Camshaft Position Actuator Adjuster Installation

Special Tools

EN-45059 Torque Angle Sensor Kit

For equivalent regional tools, refer to Special Tools .

Caution: Refer to Fastener Caution in the Preface section.

Caution: Refer to Torque-to-Yield Fastener Caution in the Preface section.





Note: A second technician is required.

1. Install the camshaft adjuster (3) and NEW camshaft adjuster bolts (2) and tighten the bolts in three passes:

Hold at the appropriate camshaft hexagon.

1.1.	First pass tighten to 65 N·m (48 lb ft)

1.2.	Second pass to 120° , using the EN-45059 sensor kit

1.3.	Third pass to 15° , using the EN-45059 sensor kit

2. Install the 2 camshaft adjuster closure plugs (1) and tighten to 30 N·m (22 lb ft).